Worx WG284, User Manual

Page: 13 / 36

13
Cordless Hedge Trimmer
EN
Side cutting
WARNING: Stop operating the
trimmer before rotating the handle.
See Fig.
K1, K2
Lubricating the cutting blade
NOTE : It is important to use
only the recommended standard
lubricating oil (WD-40) to avoid
damage to the blade.
See Fig. L
To store your hedge trimmer See Fig. M
HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and
remove any foreign objects that could become
thrown or entangled in the blades. Always
hold the trimmer with both hands and with
the blade away from you before turning it on.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade.
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Release the two Switch Levers before
attempting to clear jammed debris from the
cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
Top cutting
Use a wide sweeping motion (See Fig. E1). A
slight downward tilt of the cutting blades in
the direction of motion gives the best cutting
results.
Side cutting
When trimming the sides of the hedge, begin
at the bottom and cut upwards, tapering
the hedge inward at the top. This shape will
expose more of the hedge, resulting in a
more uniformed growth
BATTERY STATUS (See Fig. F )
Before starting or after use, press the button
beside the power indicator light on the
machine to check the battery capacity. The
indicator lights displays the battery condition
as follows:
Battery indicator
light status
Battery condition
Five green lights
(
) are
illuminated.
The two batteries are in a
highly charged condition.
Two, three or four
green lights are
illuminated.
The two batteries have
a remaining charge.
The more lights are
illuminated, the more
battery capacity.
Only one green
light (
) is
illuminated.
At least one battery is
depleted and needs to be
charged.
No light is
illuminated.
At least one battery is
not fully installed or
battery may be defective.
Only one light is
flashing twice per
cycle.
At least one battery is
over discharged (please
refer to the battery
charge condition),
please recharge the two
batteries at once before
use again or storage.
Only one light
is flashing three
times per cycle. At least one battery is
hot, wait for them cool
down before start again.
Only one light is
flashing four times
per cycle. The machine is over
load. Remove tool from
cutting area and try again.
MAINTENANCE
Remove the battery from Hedge
trimmer before carrying out any
adjustment, servicing or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working
controls free of dust.