Worx WG150 Instructions Manual Download Page 7

Grass Trimmer                                         ENG

SYMBOLS

ASSEMBLY INSTRUCTIONS

1. ASSEMBLY OF THE MAIN HANDLE AND 

SHAFT (See A)

Loosen the upper locking knob (3) clockwise.
Insert the telescopic shaft into the main handle, 
until a click sound is heard (See A).
Tighten the upper locking knob anti-clockwise.

2. ASSEMBLY OF THE SAFETY GUARD

Fix the safety guard to the trimmer head mak-
ing sure the sides are located into the grooves 
on the trimmer head (See B).
Secure the safety guard onto the trimmer head 

with  the  screw  provided  (on  the  inside  of  the 
guard).

3. ASSEMBLY OF THE SPACER GUARD

Locate  and  snap  fit  the  pivot  bracket  of  spacer 
guard into the hole of trimmer head (See C).
When  not  required,  rotate  the  spacer  guard  to 
the underside opposite side of the safety guard 
and clip into the two locations.

OPERATION INSTRUCTIONS

NOTE:

 Before using the tool, read the in-

struction book carefully.

1. CHARGING YOUR BATTERY PACK

Warning: 

The  charger  and  battery  pack 

are specifically designed to work togeth-

er so do not attempt to use any other devices. 
Never insert or allow metallic objects into your 
charger or battery pack connections because an 
electrical failure and hazard will occur. 

2.  BEFORE  USING  YOUR  CORDLESS 

GRASS TRIMMER

Your battery pack is UNCHARGED and you must 
charge once before use. Your battery pack will not 
be fully charged until you have performed several 
charge and discharge operations by charging & 
working with your grass trimmer. After this your 
battery pack performance will improve.

3.  HOW  TO  CHARGE  YOUR  BATTERY 

PACK

Connect the battery charger to the power sup-
ply and the green light (20) will illuminate 
Then, fully insert the battery pack into the char-
ger to make the connections and the red light 
(21) will illuminate to show charging has start-
ed   A discharged battery at normal ambient 
temperature will take approximately 1 hour to 
reach full charge. Charging time may vary due 
to  variable  ambient  temperatures  and  battery 
conditions.  When  charging  is  completed  the 
green light (20) will illuminate to indicate end 
of charge   . (See D)

Note: green = power on, 

red = charging,                                                                              

Battery  pack  inserted  +green  =  charging 

completed

09

08

 Read the manual  

 Warning

Do not expose to rain or water

Do not burn

Do not dispose of batteries. Re-
turn exhausted batteries to your 
local collection or recycling point.

Wear eye protection

Wear ear protection 

To  avoid  possibility  of  electric 
shock, do not use in damp or wet 
conditions.

Keep  all  other  people,  including 
children,  pets  and  bystanders  out-
side the 50 ft hazard zone, stop the 
trimmer immediately if you are ap-
proached.

CTC-WG150-M-060418.indd   8

2006-4-20   14:40:04

Summary of Contents for WG150












Reviews: