Worx WA0167, Manual, Page: 5 / 12

Chain saw extension pole EN Chain saw extension pole
5
EN
WARNING: This product can expose
you to chemicals including lead and
Di(2-ethylhexyl)phthalate (DEHP) which
are known to the State of California to
cause cancer and birth defects or other
reproductive harm. For more information
go to www.P65Warnings.ca.gov.
SAFETY INSTRUCTIONS
WARNING: Read and understand
all instructions.
Failure to follow all
instructions listed below may result in serious
personal injury.
1. When using the extension pole to cut the
branches on a tree, make sure to keep a
firm footing and balance. Do not stand in a
position where the branch may land after
being cut.
2. When using this machine with the
extension pole, make sure to insert the
battery pack to the pole firstly.
COMPONENT LIST
TECHNICAL DATA
Length 77 ˝
Extension Length 30 ˝
Weight 4.1 lbs
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully as
well as the instruction book of Chain
Saw WG322/WG323.
This extension pole is designed for use with
Worx Chain Saw WG322/WG323.
ASSEMBLY
WARNING: Before attaching the
extension pole, make sure that the
battery pack has been removed.
1. ASSEMBLING THE EXTENSION POLE
Align and insert the handle of extension
pole into the shaft. Rotate the locking knob
clockwise to lock. (See Fig. A1, A2)
NOTE:
Make sure that the shaft is firmly
locked in place.
2. ASSEMBLING THE EXTENSION POLE
TO THE MACHINE (See Fig B)
Step1: Align and insert the pole connection
bracket into the saw.
Step2: Turn the locking knob counterclockwise
to tighten the extension pole to the machine.
NOTE: Make sure the extension pole
is locked into position securely before
operation.
3. REMOVING THE EXTENSION POLE
(See Fig C)
Step1: Turn the locking knob clockwise to
loosen and pull it out.
Step2: While pulling the locking knob then
slide saw to disconnect the extension pole
with the saw.
WARNING:When using the
Extension Pole, make sure that the
battery pack has been removed.
4. ADJUSTING POLE LENGTH
The pole saw has a telescoping pole assembly
that will extend from 77 inches (fully retracted)
to 105 inches (fully extended).
Clamping lever is used to hold the pole in
position at any extended length.
1. To extend the pole, loosen the clamping
lever as shown in Fig D. Pole will slide
freely.
1. EXTENSION POLE HANDLE
2. LOCKING KNOB
3. CLAMPING LEVER
4. INNER POLE
5. LOCKING KNOB
6. EXTENSION POLE CONNECTION BRACKET
7. LOCK-OUT BUTTON
8. ON/OFF SWITCH