Worx LANDROID WG757E, Installation Manual

Page: 16 / 21

15
EN
Press then to send Landroid ® back to the charging base.
Landroid ® will follow the boundary wire to the charging base.
Fine tune the outline shape of the boundary wire if necessary.
NOTE: If the boundary wire is broken during the testing or you need to extend the boundary wire, please refer to “ Joining the
Boundary Wire ” in Owner’s Manual for instructions.
Check the status of the LED light indicator on the charging base to make sure the connection is OK.
If the verification test is completed smoothly, you can start mowing by pressing
then .
If there is any problem during verification test, please refer to “Owner’s manual-Troubleshooting”.
4
5
LED light indicator on the
charging base Status Action
Light does not turn on There is no power. Confirm that the power cord is connected properly to the
charger and that the charger is connected to a suitable
power supply.
Green light on Boundary wire is connected
successfully; Landroid
®
is fully
charged.
/
Red light on The Boundary Wire isn’t connected. Confirm that there are no breaks in the boundary wire.
Power supply is connected
successfully, while the wire is
connected unsuccessfully. Check that the boundary wire has been connected
correctly to the charging base.
Confirm that there are no breaks in the boundary wire.
Green light flashing Landroid
®
is auto charging. /
• If your Landroid
®
is
outside its territory, it will
not move and “ “
will be displayed.
Move it inside its territory
and repeat Verification.
• If your Landroid
®
is
inside its territory but
“ “ is displayed,
please refer to “ Error
Messages ” in Owner’s
Manual for solutions.
• Your Landroid ® should
always remain switched
on. If you ever need to
turn it off, then make
sure you place it within
its boundary area
before you switching it
back on again.
• Should your Landroid ®
stop operating, simply
restart it and operate it
as you normally would.
NOTE: Please refer to the Owner’s Manual for more information.
Warning
Only for reference