Lawn Mowing Robot
EN
12
5. Software update
Your Landroid
®
M software can be updated when new versions
become available. You can check the software version installed on
your machine by pushing the ON/OFF button. The software version
will be displayed in the bottom right hand corner of the display.
The latest software can be downloaded from our website – see
below download and installation instructions;
Step 1: Locate the latest software version at : www.worxlandroid.com.
Copy the “.bin” file containing the latest software version to a USB
memory stick.
NOTE: Before transferring the “bin” file make sure the
memory stick does not contain other files or data.
Step 2: Remove the battery cover and insert the memory stick into
the USB port . (See Fig J1)
Step 3: Press the ON/OFF button for ten seconds until the mower
is powered ON. The new software version will be displayed in the
bottom right corner of the display. (See Fig J2)
Step 4: Remove the memory stick and refit the battery cover.
Step 5: After installing the new software you will need to reset the
diagnostic panel on your mower. Firstly, position the mower on a
horizontal surface.
Press Key “2” to enter the diagnosis interface, then press key
“5” for a few seconds until the three numbers 1 2 & 3 highlighted
below turn back to zero. (See Fig J3)
6. Maintenance
Your Landroid
®
M needs to be checked from time to time. The
Landroid
®
M works hard and after time needs a good cleaning as well
as having some parts replaced, as they can become worn.
In the following we want to let you know how to take care of your
Landroid
®
M.
6.1 Keep it sharp
WARNING: Before cleaning, adjusting, or replacing
the Blades, turn your Landroid
®
M OFF by pressing
the ON/OFF Button to OFF and put on protective gloves.
WARNING: When fitting new blades, make sure
you replace ALL the blades. Always use new
screws when fitting blades . This is important to ensure
blade retention. Failure to use new screws could cause
serious injury.
The Landroid
®
M does not cut grass like other mowers. Its
Cutting Blades (14) are razor sharp on all 4 edges and spin in
both directions for maximum cutting capacity (See Fig. K ).Each
blade of your Landroid
®
M has 4 cutting edges. Depending on the
frequency the Landroid
®
M mows your lawn, the cutting blades will
need to be flipped/rotated periodically for a new cutting edge. If
your Landroid
®
M is programmed to mow the lawn every day then
the cutting blades will need to be rotated monthly for the best
mowing results. Each cutting blade will last up to 4 months when
it is programmed to mow every day. When the cutting blades are
dull and worn out, they should be replaced with the spare blades
provided with your Landroid
®
M. Spare blades are also available at
your nearest WORX retailer.
1
2
3
J1
J2
J3
4
3
1
2
K
