Worx Jawsaw WG307E, Manual

Page: 20 / 102

Limbing and Trimming Electric Chain Saw En
21 20
TROUBLESHOOTInG
If your saw does not operate correctly check the following:
PrOBLEMS POSSIBLE CAuSES POSSIBLE SOLuTION
Tool will not start.
Fuse blown or breaker
tripped.
Extension cord not plugged
in. Check fuse or breaker.
Check to make sure extension
cord is plugged into a
working outlet.
Bar/chain overheated.
Chain too tight.
Lubrication needed.
Refer to
ADJuSTINg THE
CHAIN TENSION
section.
Refer to
LuBrICATION
section.
Chain is loose.
Chain tension set incorrectly.
Refer to
ADJuSTINg THE
CHAIN TENSION
section.
Poor cut quality.
Chain tension set incorrectly.
Chain needs replacement.
Refer to ADJuSTINg THE
CHAIN TENSION section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
Refer to sections for
CHANgINg THE guIDE
BAr AND CHAIN.
Unit runs but does not cut.
Chain installed backwards.
See Fig H and illustration.
Refer to
CHANgINg THE
guIDE BAr AND CHAIN
section.
EnVIROnMEnTAL PROTECTIOn
This product has been marked with a symbol relating to removing electric and electronic
waste. This means that this product shall not be discarded with household waste but that it
shall be returned to a collection system which conforms to the European Directive 2002/96/
CE. It will then be recycled or dismantled in order to reduce the impact on the environment.
Electric and electronic equipment can be hazardous for the environment and for human health
since they contain hazardous substances.