Worx HydroShot WP650E, Original Instructions Manual

Page: 13 / 124

EN
20V Sanitizing pressure washer
13
TROUBLESHOOTING
Symptom Possible causes Solution
Machine turns on but it
does not draw any water
or there is not sufficient
pressure. The water inlet is loose. Retighten the water inlet.
The filter screen is missing. (See Fig.
L1, L2) Contact Worx service agent to get a filter
screen.
Machine does not start.
The battery pack is not attached well. Reinstall the battery pack.
Battery pack is empty. Replace with a new battery pack or recharge the
battery pack.
Defective battery. Replace with a new battery pack.
Machine stops
automatically. Battery pack is empty. Replace with a new battery pack or recharge the
battery pack.
Machine does not draw
any water after long time
storage.
Additional air could be sucked into
the machine. It is recommended to pour water directly into
the hose adapter with the machine turned on
to empty the air. Ensure water sprays out of the
nozzle before working.
Machine sprays
improperly.
Nozzle is clogged, hose is partially
disconnected, or fluid in tank is low. Clean the filter. Check hose connections
and make sure there is sufficient fluid
in the tank.
Machine is “spitting”.
Liquid in tank is too thick to spray
out. Empty the tank, clean both the tank and filter,
then try again. Make sure that all liquid used in
the sprayer are as thin as water.
Spraying performance
is weak
Filter needs to be cleaned.
Solution is too thick. Clean the filter.
Make sure that all liquid used in the
sprayer are as thin as water.
Machine runs for a short
period then shuts off.
Battery needs charging.
Solution is too thick. Recharge the battery.
Make sure that all liquid used in the
sprayer are as thin as water.