Worx Nitro WG330E, Safety And Operating Manual

Page: 17 / 20

17
3. When pruning the entire stem, please cut the stem
from the point where it branched.( See Fig P )
6. MAINTENANCE
WARNING: When you need to start inspection,
maintenance and cleaning work, please make sure
the product has been switched off, it has cooled down and
the battery pack has been removed.
1. Never use solvents to clean the product and never
immerse the product in any liquid. Only use a dry cloth to
clean the product.
2. Never directly operate the product if some broken or
worn parts are found. Please inspect the product before
each usage.
BLADE MAINTENANCE
1. When need to sharpen the blades, please open the
blades to the max cut opening , turn the product off and re -
move the battery. Then use a strip of grindstone to sharpen
the blades in a careful way.
2. Always keep blades free of leaves or debris.
WARNING: Wear protective gloves while clean and
sharpen the blades.
7. STORAGE
WARNING: When not in use, please press the on/
off switch for a long time to close the blades as
operation instruction shown.
1. Keep the product in a dry place and never let it immerse
into any liquid.
2. keep the product from away from children.
3. Before use the product after long-time storage, please
fully recharger the product.
8. ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authorities or retailer for
recycling advice.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery use
and storage is 0
o C
-45
o C
.
The recommended ambient temperature range for the
charging system during charging is 0
o C
-40
o C
.