Fumes and gases can be dangerous.
■
Cutting may produce fumes and gases hazardous to health. Avoid breathing these fumes and gases.
When cutting, keep your head out of the fume. Use enough ventilation and/or exhaust at the arc to
keep fumes and gases away from the breathing zone.
■
Use enough forced ventilation or local exhaust (forced suction) at the arc to remove the fumes from
your breathing area.
■
Wear complete body protection. Wear oil-free protective clothing such as leather gloves, heavy shirt,
cuffless pants and high boots.
Arc rays can burn eyes and skin.
■
Use welding helmet with correct shade of filter to protect your eyes from sparks and the rays of the
arc.
■
Wear welders cap and safety glasses with side shields. Use ear protection when welding out of position
or in confined spaces. Button shirt collar.
■
Use a ventilating fan to remove the fumes from the breathing zone and welding area.
Welding sparks can cause fire or explosion.
■
Remove fire hazards from the welding area. If this is not possible, cover them to prevent the welding
sparks from starting a fire. Remember that welding sparks and hot materials from welding can easily go
through small cracks and opening to adjacent areas. Avoid welding near hydraulic lines.
■
When not use, make certain no part of the electrode circuit is touching the work or ground. Accidental
contact can cause overheating and create a fire hazard.
■
Do not cut on drums, tanks, or any closed containers unless a qualified person has tested it and
declared it or prepared it to be safe.
■
Connect the work cable to the work as close to the cutting area as practical. Work cables connected to
the building framework or other locations away from the cutting area increase the possibility of the
cutting current passing through lifting chains, crane cables or other alternate circuits. This can create
fire hazards or overheat lifting chains or cables until they fail.
■ INSTALLATION
● The welding machine shall be installed at a place ;
․
free from the inflammables
․
less humidity, dirt and dust
․
protecting from influence of direct sunlight, wind and rain
․
not generated oil vapor and corrosive gas
․
operating temperature range is from -10℃ to 40℃
․
least 30㎝ away from wall and other welding machine
● Input Connection (Rear of the machine)
Be sure the voltage, phase and frequency of the input power is as specified on the name plate
located on the rear panel of the machine.
․
To connect the power cables, turn the power switch OFF
․
Verify the voltage to be supplied from main power.
․
Connect the power cables to the power input cables on the rear of the machine. For grounding the
machine, connect a ground wire to the ground terminal marked with the symbol is located on the rear panel
of the machine.
