Worldlawn WY 48FS481V, Operator'S Manual

Page: 3 / 12

2
Assembly Instructions
Fig. 1
upper handle into position. (Remember
that there are 3 – height settings for the
handle for operator comfort.) Route the
wiring harness along the handle,
plugging it into the blade control switch,
using the screws to attach the harness to
the Operator Presence Control switch.
There is not a specific color for hooking
up the harness.
SPECIFICATIONS
Belt Tension Guide
Belt
Engine to Deck
Transmission Belt
Right Blade Drive Belt
Wheel Drive
Inch Deflection
1/2”
1/2”
1/2”
(48”,52”, And 60” only)
1/2”
How to Adjust
Turnbuckle at Idler
Sliding Idler
Threaded Rod to Idler
Self-Adjusting
1. Remove inner parts box and handle from
crate. Remove outside frame work so
that the mower is setting on the pallet.
2. On a 36" mower, use 3 – 5/16" X 1 3/4"
bolts and 3 – 5/16" whizlocks and bolt the
bumper into place. (On the 48" there are
4 - bumper bolts required.)The whizlocks
should go to the inside of the deck.
When assembling a 48" mower, make
sure that the bumper is flush with the
deck on both ends of the bumper.
3. Using 6 – 3/8" X 1" bolts (3 – used for
each caster) and 6 – 3/8" whizlock nuts,
bolt the casters into place. Position
whizlock nuts to the inside of the deck.
4. Using 2 – 5/16" X 1" bolts with 2 – 5/16"
flat washers and 2 – 15/16" nyloc nuts,
take the shifter lever with grip and bolt
onto the top side of the shifter bracket on
the transmission. Place the 5/16" flat
washers on the slotted hole side of the
shifter bracket under the 5/16" nut.
Position the shift lever so that it slides
freely along the top side of the shifter
plate but still hits the stop for reverse.
5. Mount the gas tank using the 2 – nylon
hold down straps, pulling tension on the
buckles until secure. Attach the fuel supply
from the tank to fuel filter on the engine.
Attach vapor recovery line on engine to
the vent barb on the tank, Secure all connections
with hose clamps.
6. Using the remaining 4 - 3/8" X 1" bolts
and the 4 – 3/8" nyloc nuts, bolt the