Worldlawn Venom WYS32FS600VL, Operator'S Manual

Page: 31 / 44

31
CHECK HYDRAULIC OIL LEVEL
Stop engine, wait for all moving parts to stop and
remove key. Engage parking brake.
The transaxles are lubed for life. No maintenance
should be required.
Oil level can be checked using the dipstick on the
breather cap on each axle, located on the top front
of each axle.
CHECK TIRE PRESSURES
Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop
and remove key. Engage parking brake.
2. Check tire pressure in.
3. Inflate drive tires to 12-14 psi (83-97 kPa).
4. Inflate caster tires to 15psi.
CHECK CONDITION OF BELTS
Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop
and remove key. Engage parking brake.
2. Look on the top side of the cutting deck to
check the mower blade drive belt condition.
3. Look under the engine deck to check the pump
drive belt condition.
4. Check all idler arms to be sure they pivot freely.
LUBRICATE GREASE FITTINGS
Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop
and remove key. Engage parking brake.
2. Lubricate fittings with NGLI #2 multi-purpose
grease.
Lubrication Chart
FITTING
LOCATIONS
INITIAL
PUMPS
NUMBER
OF
PLACES
SERVICE
INTERVAL
1. Motion
Control
Levers 1 2 Yearly
2. Front Caster
Wheel Hubs
0 2 Weekly
3. Front Caster
Pivots
0 2 Yearly
Grease points:
1. Deck Lift Lever
2. Pump Idler Pivot
3. RH Deck Lift Crank
4. LH Deck Lift Crank
5. RH Front Lift Crank
6. LH Front Lift Crank
7. RH Caster Wheel
8. RH Caster Pivot
9. LH Caster Wheel
10. LH Caster Pivot