Worldlawn PYTHON WYP72BSV37EV5, Operator'S Manual

Page: 22 / 48

22
DRIVING IN REVERSE
1. Move the motion control levers to the
neutral operate position.
2. To move rearward in a straight line, slowly
move both levers rearward with equal
pressure.
To turn left or right, release pressure on the
motion control lever toward the desired turn
direction.
3. To stop, position both motion control levers
in the neutral operate position.
ADJUSTING THE CUTTING HEIGHT
The cutting height of the mower deck is
adjusted from 1.5 to 5.25 inches (3.8 cm to
13.3.0 cm) in 1/4-inch (6.4 cm) increments.
1. Stop the machine and move the motion
control levers to the neutral position.
2. Disengage the PTO.
3. Raise to the 5-1/4-inch (13.3 cm) transport
position.
The deck is raised by pushing the deck lift
switch up. The switch is located on the right
side of the console.
Note: When changing the cutting height
positions, always come to a complete
stop and disengage the PTO.
4. Insert the height adjustment pin into the
hole corresponding to the desired cutting
height.
See the decal on the side of the deck lift
plate for cut heights.
5. Push the deck switch down to lower the
deck to cutting height.
ADJUSTING THE ANTI-SCALP ROLLERS
It is recommended to change the anti-scalp
roller position when the height of cut has
changed.
1. Stop the machine and move the motion
control levers outward to the neutral locked
position.
2. Disengage the PTO.
3. Engage the park brake.
4. Stop the engine, remove the key and wait
for all moving parts to stop.
5. Place the rollers in one of the positions
shown. Rollers will maintain 3/4-inch (19
mm) clearance to the ground to minimize
gouging and roller wear or damage.
For cutting heights above 3.5 inches (90 mm)
use the bottom hole. The rollers will still be
effective against scalping.
For Maximum Deck flotation, place the rollers
one hole position lower. Rollers should
maintain 1/4 (6.4 mm) clearance to the ground.
Do Not adjust the rollers to support the deck.