STEP- 1
With help of 2 pe
ople
place Top (A) upside down on padded non-marring surface. Position each Leg (B)
to the underside of the Top (A) so that Leg holes are aligned with holes at the underside of the Top (A).
Install Leg (B) to Top (A) using
3
pieces
Flat Washers (H3),
3
pieces
Spring Washers (H2) and
3
pieces
Bolts (H1), stacking hardware in the order as shown above. Repeat the same step for the other
leg. Make sure all bolts are fully engaged into the pre-installed inserts at the top’s underside before fully
tighten, using Allen Key (T1).
STEP-
2
B
A
Assembly Steps
Page
4
H1 - M4 x 24mm
(3X)
H2 -
15mm x 9 mm
(3X)
H3 -
23mm x 10 mm (3X)
3X
3X
