World Cat 2013 320CC, Onwers Manual, Page: 54 / 95

2013 World Cat 320CC Owners Manual
activate the pump by momentarily lifting the arm on the float switch, then check the operation using the manual
switch. When testing, do not allow the pumps to run dry for more than two to three seconds. Extended dry operation
can result in damage to your pump. Keeping your bilge areas clean can also help extend the life of your pump.
10.1.4 Freshwater System
The freshwater pump is mounted to the hullside and can be reached through the access door in the starboard gunwale.
The pump is connected to the 20 gallon freshwater tank located in the hull forward of the starboard fuel tank. The
tank is filled through a fitting located on the starboard side of the deck. Similar to residential well pumps, the
freshwater pump pressurizes the system to 45 psi. then shuts down until the pressure drops below that level. Most
owners leave the pump “on” throughout the day, and use the system when necessary. On the 320CC, the freshwater
pump feeds the pull out shower located on the aft transom wall, freshwater wiper rinse and the marine head. To view
the layout of the freshwater system see the drawing on page 15.
10.1.5 Seacocks
Ball valves (seacocks) are installed on the water intake for both the livewell and raw water system. The seacock must
be in the open position for these systems to work. When open, the handle will be parallel to the valve. In the closed
position the handle is perpendicular to the valve (see picture below). World Cat recommends that the seacocks remain
in the closed position when not in use, or when the boat is left unattended to prevent the vessel from taking on water
due to a plumbing failure.
OPEN CLOSED
10.1.6 Livewell System
Page 10-53