World Cat 2013 255DC, Owner'S Manual

Page: 57 / 89

2013 World Cat 255DC Owners Manual
evacuate the bowl.
The holding tank is mounted in the port side aft of the changing, it can be accessed through the inspection plate
located above and outboard of the compartment steps. This tank can be evacuated using the deck pump-out fitting
located forward of the companion seat or by overboard discharge using the macerator pump and seacock supplied on
your vessel. To access the seacock, open the inspection hatch installed in the port gunwale. Open the seacock and use
the keyswitch on the head switch panel to evacuate the tank.
1.1.1.1.Initial Start Up
On each trip, prior to using the head, complete the following steps:
1. Turn on the freshwater system.
2. Fill 1/3 of the bowl with water using the lower switch on the control panel
3. Hold down the flush switch for 5 seconds to evacuate the bowl and refill with water.
1.1.1.2.Normal Use
Use the steps below for normal operation.
1. Hold the upper switch on the panel down for 5 seconds. This will purge the bowl and refill it with water.
2. In the event of inclement weather or rough seas, use the lower switch to remove water from the bowl and
prevent sloshing.
Page 10-56
!
!
!
!
!
!
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Large quantities of waste or paper can clog the head and cause odor issues. To prevent this, flush often
and if necessary perform an extra flush to purge the discharge line.
!
!
!
!
!
!
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Do not dispose of foreign objects in the head. Doing so may damage the macerator pump or outlet hoses.
Clogging or puncturing these lines will lead to odor problems.
1.1.1.3.Deck Pump Out
Upon returning, use the following instruction to empty the holding tank.
1. Remove the cap from the deck pump-out fitting located on deck aft of the port berth entrance.
2. Use the vacuum hose at the pump-out station to clean the tank, then remove the hose and replace the deck
fitting.
1.1.1.4.Overboard Discharge
Use the following steps to discharge the contents of the holding tank overboard:
1. Access and open the overboard discharge seacock through the inspection port directly above the compartment
step..
2. Use the “Accy2” switch on the digital pod located near the helm to evacuate the tank. The discharge thru-hull
is located inside the tunnel on the port sponson.
3. Inspect the tank level through the inspection port outboard of the compartment step and repeat step 2 if needed,
otherwise close the discharge seacock.
!
!
!
!
!
!
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Discharging waste in inland waters and some coastal areas is illegal. Check with local and state
authorities in your region to determine the proper method for waste disposal.
For more instructions on operation, winterization and troubleshooting the marine head, see the Jabsco™ manual
supplied in your “Owner’s Portfolio”. For diagram refer to section 10.3.11 of this manual
10.2 M
AXIMUM
H
ORSEPOWER
R
ATING
: T
WIN
175 4-S
TROKE
HP (350 HP
TOTAL
)
10.3 O
PERATION OF
O
PTIONAL
E
QUIPMENT
10.3.1 Stereo