Workzone Titanium+ AG36, Instruction Manual

Page: 12 / 36

12
12
AFTER SALES SUPPORT
1300 889 028 (toll free)
e-mail:
MODEL No.:
info.aldi@positecgroup.com
AG36 • 8290 • 06/2019
position yourself and bystanders away from the plane
of the rotating accessory and run the power tool at
maximum no-load speed for one minute.
Damaged accessories will normally break apart during this test
time.
h) Wear personal protective equipment. Depending on
application, use face shield, safety goggles or safety
glasses. As appropriate, wear dust mask, hearing
protectors, gloves and workshop apron capable of
stopping small abrasive or workpiece fragments.
The eye
protection must be capable of stopping flying debris generated by
various operations . The dust mask or respirator must be capable
of filtrating particles generated by your operation. Prolonged
exposure to high intensity noise may cause hearing loss.
i) Keep bystanders a safe distance away from work area.
Anyone entering the work area must wear personal
protective equipment.
Fragments of workpiece or of a broken
accessory may fly away and cause injury beyond immediate area
of operation.
j) Hold the power tool by insulated gripping surfaces only,
when performing an operation where the cutting tool
may contact hidden wiring.
Contact with a “live” wire will
also make exposed metal parts of the power tool “live” and
could give the operator an electric shock.
k) Never lay the power tool down until the accessory has
come to a complete stop.
The spinning accessory may grab the
surface and pull the power tool out of your control.
l) Do not run the power tool while carrying it at your side.
Accidental contact with the spinning accessory could snag your
clothing, pulling the accessory into your body.
m)Regularly clean the power tool’s air vents.
The motor’s fan
will draw the dust inside the housing and excessive accumulation
of powdered metal may cause electrical hazards.