11
After Sales Support
1300 663 907
Model Number
DY160121
AUS
Set Up
Set Up
NOTE:
The Step Smart unit has been designed to fit to most ladders, however in
some cases you may not be able to mount the unit to your ladder in which case,
do not attempt to use the Step Smart device
1. Ensure your ladder is set up as per your user manual and is on a level
surface
2. Select a gap between the rungs where you can mount the device
horizontally
NOTE:
If possible, we recommend that the unit is mounted around eye level for
better visibility
3. Unclip the red telescopic bracket clip to allow the size of the bracket to
be adjusted
4. Extend the right-hand bracket plate until
both bracket plates push against the
inside wall of your ladder and close the red
telescopic bracket clip
5. Slowly push the unit upwards so the device
is flush to the underside of a rung, ensure
there is a tight fit. As most ladders taper
upwards, it will fit more securely as you push
it up
NOTE:
The device must be installed directly under
a ladder rung to ensure it does not become an
obstruction with your feet when climbing up or
down the ladder
6. Press the Power button to enter Set Up
Mode, you will hear one short beep. In Set
Up Mode, the Red and Green LEDs will flash
to indicate level, but no alarm will sound
NOTE:
Refer to page 14 for more details on the
Display Functions
Summary of Contents for Step Smart
Page 16: ......
