20
21
www.coreservice.co.uk
AFTER SALES SUPPORT
IRE
+353 (0) 19022605
GB
www.coreservice.co.uk
AFTER SALES SUPPORT
IRE
+353 (0) 19022605
GB
Q1W-SP14-1900A
Q1W-SP14-1900A
+44 (0) 190 472 7501
+44 (0) 190 472 7501
Maintenance
6
DANGER
of electrocution
Before carrying out any maintenance and cleaning work, switch the machine
off and remove the plug from the socket.
Do not clean the machine with a high-pressure jet of water!
Cleaning
Machine
Clean the machine and accessories by wiping it with a slightly damp cloth.
Dirt filter
The high-pressure washer is equipped with a dirt filter to protect the pump. If this filter
is not kept clean, the flow of water to the machine is restricted, and will damage the
pump.
•
Check the filter every time you use the machine and clean it, if necessary. To do this,
proceed as follows:
-
Unscrew the adapter for the water intake (14) and lift out the filter (arrow).
(Figure 17)
-
Rinse out the filter until it is free from deposits and dirt.
-
Re-insert the filter and the adapter.
High-pressure nozzle
Where necessary, clean the high-pressure nozzle using the nozzle needle (15) that
is supplied. (Figure 18)
Maintenance
The high-pressure washer's pump does not require maintenance. No additional care
measures are required.
Storage, transport
7
ATTENTION
Machine may be damaged by frost
There is always residual water left inside the high-pressure washer and in
the pump. Do not store the machine at temperatures below freezing point
in order to avoid frost damage.
Storage
Accessories
The spray lances and the rotating brush can be kept in the accessories compartment
beside the detergent tank on the back of the machine.
•
Keep the spray gun in the bracket for the spray gun (3) by clicking it into place with
the handle facing up.
Machine
•
In order to store the machine, unscrew the high-pressure hose from the threaded
connector for the spray gun and wind the hose around the hose reel.
ATTENTION
In order to rewind the high-pressure hose, the crank of the hose reel may
only be rotated clockwise. The hose and the machine may be damaged if the
hose is rewound in the opposite direction.
•
Secure the end of the hose with the hose clamp, as shown in figure.
Summary of Contents for Q1W-SP14-1900A
Page 2: ...2 3 ...
