8
9
AFTER SALES SUPPORT
0800 / 328 6020 [email protected]
00800 / 4467 5888
GT-DC-02, 02/13, E45316
AFTER SALES SUPPORT
0800 / 328 6020 [email protected]
00800 / 4467 5888
GT-DC-02, 02/13, E45316
(4) Press the On/Off key in order to switch off the power; if the slider
is no longer used after the end of the measurements, the display
will switch off after approx. 4-5 minutes.
Inserting the battery
An abnormal display (flashing numbers or no display at all)
indicates a low battery voltage and the battery must be
replaced. Remove the battery lid in the direction of the arrow
and insert the battery or replace a used battery with a new one.
When inserting, pay attention to the correct polarity, the positive
terminal of the battery must be pointing upwards. Close the lid
again after inserting the battery. If the battery supplied with the
product does not work correctly (e.g. the voltage is low due to
being stored for too long), please contact the supplier.
Note:
1. After inserting the battery, the caliper gauge requires several
seconds (approx. 5-6 seconds) in order to set itself. The caliper
gauge can only be switched on again after the end of the setting
process.
2. Reset the zero point of the measurement after replacing the
battery.
Instructions for batteries
• Never attempt to recharge non-rechargeable batteries.
Explosion hazard!
• Keep batteries away from children, do not throw them into fire,
do not short-circuit batteries and never dismantle batteries.
• Immediately contact a doctor, if a battery has been swallowed.
• Clean the battery and device contacts prior to insertion, if
required.
• Immediately remove depleted batteries from the device.
Increased leakage hazard!
• Do not expose batteries to any extreme conditions, e.g. on
radiators, direct sunlight! Increased leakage hazard!
• Failure to comply with this could result in batteries being
discharged beyond their final charge voltage and leaking.
Remove batteries immediately, in order to avoid damage.
Summary of Contents for GT-DC-02
Page 11: ......
