Air Compressor
AFTER SALES SUPPORT
(toll free)
MODEL No.: PAP110 • 02/2019 63569
e-mail: [email protected]
AUS
10
1300 889 028
AUS
Operating Instructions
NOTE: Before using the tool, read the instruction book
carefully.
Intended Use
This Air Compressor is designed to generate compressed air for
compressed-air driven tools which can be driven with an air volume of
up to approx. 180 l/min (e.g. tyre inflator, blow-out pistol and paint
spray gun). Due to the limited air output it is not possible to use the air
compressor to drive tools with very high air consumption (for example
orbital sanders, rod grinders and hammer screwdrivers).
The equipment is to be used only for its prescribed purpose. Any other
use is deemed to be a case of misuse.
Preparation
Before you connect the equipment to the mains power supply make
sure that the data on the rating plate are identical to the mains data.
●
Install the air compressor near the point of consumption.
●
Avoid long air lines and supply lines (extension cables).
●
Make sure that the intake air is dry and dust free.
●
Do not install the air compressor in a damp or wet room.
●
The air compressor may only be used in suitable rooms (with good
ventilation and an ambient temperature from +5 °C to 40 °C). There
must be no dust, acids, vapors, explosive gases or inflammable gases
in the room.
●
The air compressor is designed to be used in dry rooms. It is
prohibited to use the compressor in areas where work is conducted
with sprayed water.
Operating Instructions
