10
WeT/DRY vAc AssemblY
(Ws1200vAeX0)
1.
Line up front of power head assembly
with vacuum port located on the front
of the drum, as shown.
2.
Place power head assembly on top of
drum.
3.
Be sure lid completely covers the top
of the drum so leakage does not
occur.
4.
Push down on top of the drum latch
areas to cause the flexible locking
tabs to hook onto the drum channel.
5.
Make sure that the locking tabs are
snapped in place to prevent the lid
from coming off. (See inset).
Drum
Channel
Top
Assembly
Push Down
Push Down
Pull Out
Flexible
Locking
Tab
Drum
Out
Flexible
Locking Tab
Insert hose
Insert the push button end of the Dual-
Flex™ Locking hose into the inlet of the
Vac. The hose should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
Release
Button
Vacuum
Port
Power Head
Assembly
(Ws1600cAeX0)
Release
Button
Press and Pull
Vacuum
Port
Power Head
Assembly
(Ws1200vAeX0)
SP6935 Workshop _SP6439-3_ES.qxd 12/17/14 1:33 PM Page 10
