Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
11 of 11
#1500451 Rev A
11
Put Workcenter Upright and Connect Power Cord to the Power Supply
11.1 Turn the workcenter over into an upright position.
Note: Always use at least two people to flip and move Workcenters. Caution! Heavy!
11.2 Plug the Power Cord (U) into the power outlet.
12
Adjust Feet Glides
If necessary, adjust Foot Glides (M) on the feet to level the worksurface. Unscrew to increase height, screw in to
decrease height.
✓
Cleaning instructions
To clean the Sierra legs, apply cleaner to a soft cloth.
Suggested cleaners: Windex or Formula 409.
Do not use solvents and do not saturate or spray cleaners directly to workcenter base.
You must complete this
initialization step or your
workcenter will NOT
function properly.
Hold down the down
arrow until workcenter
moves slightly upwards!
✓
Replacement Parts
Visit
http://workriteergo.com/documentation/other/workrite_ergonomics_pricing_specification_guide.pdf
for
replacement parts.
13
Initialize Legs
After all legs and the switch are connected, and the power cord has been plugged in, hold the
down arrow on
the switch until the legs make a short motion down and then back up. This initializes and synchronizes the
workcenter legs.
U
11.1
11.2
