&
Make Adjustments & Secure Cables
8
Horizontal & vertical adjustments is made by using the VESA Mount
Knob (F) and Ratchet Lever (D). You may need to re-position the
Collar (C) to lower or raise the Wing Bar on the Pole.
Arc adjustment is made by pulling the Wing Mount monitors towards
you or pushing away from you.
Guide monitor and power cables over and around
Ratchet Levers and Wing Knobs then through the
Cable Manager (B).
Monitor Tilt & Swivel Adjustments
Depending on the size of your monitor, it may be necessary to adjust
the tilt and swivel setting.
If the monitor doesn’t hold its tilt position or is too hard to tilt, adjust
the tension adjustment on top of the Monitor Mount. Use the 2.5mm
Hex Wrench (I), clockwise to increase lift, counter-clockwise to
decrease lift. Check the monitor, and adjust again as necessary.
a
b
c
Important Note
It is recommended to have two people adjusting multiple monitor
configurations after monitors are mounted to the arm assembly.
!
Swivel
+/- 20°
Tilt
+/- 20°
Horizontal Adjustment
with VESA Mount Knob
Vertical Adjustment with
Ratchet Lever & Collar
Arc Adjustment
+/- 10°
B
B
I
J
K
F
