Attach Wing Bars to Pole
Attach Monitors to Wing Bars
4
5
Place Left first then Right Wing Bars (L) onto Pole and
rest on Collar (C). Dual Wing Bars are identical and
interchangeable.
Install Ratchet Lever (D) into the rear of the Wing Bar
and tighten.
a
b
a
b
Note: During installation it may be necessary to adjust
overall height of the assembly. To do this simply
loosen the Allen set screw (G) in the Collar( C) with
the 2.5mm Hex Wrench (I) and move accordingly.
Retighten the Allen Screw and Wing Bar Mount when
desired height is reached.
Align the Outside VESA Mount (K) with the slot in the
Wing Bar. Place Plastic Washer (E ) onto the Mount
Knob (F). Install the Knob and Washer into the Mount
as shown and tighten securely.
Repeat for the remaining outer monitor.
Note: During assembly it may become necessary
to adjust the width of the outer monitors to adjust
for curved alignment and minimize gaps between
monitors. To do this simply loosen, move, and retighten
the Mount Knob (F) to the wing bars.
c
D
D
C
L
F
E
K
F
c
a
Left
Right
a
b
