6 of 10
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Attach Control Box & Cable Spools to Worksurface
Position Control Box (H).
If you have a Workrite worksurface:
Locate the two pilot holes for the Control Box and proceed to
Step 6b.
If you do not have a Workrite worksurface:
Place Control Box (H) in position and use a pencil to mark pilot hole placement. Control Box should be placed
towards rear center of worksurface as shown. Remove Control Box and drill pilot holes where marked.
Do not drill all the way through worksurface!
With Control Box (H) positioned over pilot holes, attach with two #12 × ¾" Pan Head Screws (G).
Attach Cable Spool (I) with the #12 × ¾" Pan Head Screw (G) to underside of worksurface. If you do not have a
Workrite worksurface, mount Cable Spools (I) in a convenient location between Legs and Control Box.
Attach Feet (sold separately)
Refer to foot kit instructions for steps to install your feet.
a
a
b
c
c
c
b
6
G
G
G
H
G
5
I
I
G
#12 × ¾" Pan Head
Laminate Top Screw
Hardware at actual size
#M6 × 12 mm Flat Head Cap
Screw
Hardware at actual size
Note!
Only use the #M6 × 16 mm Flat Head Cap
Screw from the Foot Kit for assembly.
