1 of 4
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
A
Conform Articulating Arm
Qty: 1
B
M4 × 10 VESA
mount screw
Qty: 4
D
Pivot Cover Cap
Qty: 1
C
M4 × 6 VESA
mount screw
Qty: 4
Parts Included
Required Parts Sold Separately
Tools Required
Assembly & Installation Instructions:
Conform Articulating Arm CONF-1SDA-WOB-S
Attach Conform Articulating Arm to Selected Base Option
Remove Bolt and Washers from base (if not already removed.)
Place the Conform Arm (A) on the Base Pin.
Assemble Bolt with Washers as shown. Insert through the
bottom of the arm assembly and into the base. Tighten with
5 mm Allen wrench. Be sure the arm is tight but rotates freely.
Snap Pivot Cover Cap (D) into top of arm assembly.
#2 Phillips head screwdriver
2.5 mm Allen wrench included with base
5 mm Allen wrench included with base
Selected base option with mounting hardware
Do not use on hollow core tables.
Do not rotate or suspend arm beyond table surface.
Do not exceed 17 lb.
M8 Flat Head Cap Screw
M4 8mm Screw
M4 12mm Screw
M4 16mm Screw
Spacer
Plastic Cap
7/32” Allen Wrench
1/8” Allen Wrench
Button Head Allen Cap Screw
Pivot Pin
Steel Washer
Plastic Pivot Washer
1
a
a
b
b
c
d
d
c
D
A
C-Clamp Mount shown
Remove
Replace
Base Pin
