Workrite Ergonomics Conform Base CONF-BSE-TSB-S Assembly/Installation Instructions Download Page 3

Page: 3 / 4

3 of 4

Workrite Ergonomics | 800.959.9675 www.workriteergo.com

Ready for Arm Installation

You are now ready to attach your selected Conform Monitor Arm (sold separately). Follow Arm installation

instructions.

Articulating Arm

Shown

After M8 x 90 mm bolt has been

installed and set screw has been

tightened with 2.5 mm Allen

Wrench (D), apply the sticker (F) to

cover the set screw.

Note:

Summary of Contents for Conform Base CONF-BSE-TSB-S

Page 1: ...ONF BSE TSB S Attach the Base to Tool Bar Using a Phillips head screwdriver open or close the jaws so the metal clips grip both the top and bottom of the Tool Bar Slatwall and slide Required Parts Sol...

Page 2: ...ate the screw clockwise to tighten the grip to the Tool Bar Slatwall Once the metal clips are tightened the Base will not be able to move along the rail unless it is loosened again Insert Spacer and B...

Page 3: ...u are now ready to attach your selected Conform Monitor Arm sold separately Follow Arm installation instructions Articulating Arm Shown 4 After M8 x 90 mm bolt has been installed and set screw has bee...

Page 4: ...clip with the alternate clip G with lip up as shown below Using a Phillips head screwdriver rotate the screw clockwise until the two clips are roughly positioned for placement on Slatwall Return to st...