2 of 2
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Attach selected Conform Arms to the Single Pole Mount Adaptor.
Remove Bolt and Washers from Pin Assembly.
Choose the appropriate Spacer for the selected Arm Assembly then place it onto pin.
Place Conform Monitor Arm on Pin, resting on Spacer.
Assemble the Bolt and Washers as shown (M8 x 72 mm Bolt for Static Arm, M8 x 80 mm Bolt for Articulating Arm).
Tighten with 5 mm Allen Wrench included with base. Be sure the arm is tight but rotates freely.
Tighten the pre-installed set screw with 2.5 mm Allen Wrench, included with base, to lock in place.
Snap on the Pivot Cover cap for your arm.
2
c
d
e
f
f
g
g
g
a
b
1500263 Rev A
a
b
Remove
or
or
Articulating
Arm Spacer
B
Static Arm Spacer
included with
C
14" Pole shown
Articulating Arm mount
Static Arm mount
c
c
d
d
e
e
A
C
Pin with
Articulating
Arm Spacer
B
Pin with Static
Arm Spacer
from
C
Replace
Static Arm
Pivot
Cover Cap
Pivot
Cover Cap
Articulating
Arm
Align peg in arm
with cutout in
spacer
pre-installed
set screw
