2 of 2
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Attaching Conform Articulating Arms
Remove the set of two M8 × 66 mm Bolts and Washers from the
Dual Arm Adaptor.
Place the Conform Arm on the Dual Arm Adaptor post. Align
tooth in arm base with notch in plastic washer.
Insert the M8 × 66 mm Bolt with washers through the bottom of
the arm assembly and into the Adaptor as shown. Tighten with
5 mm Allen Wrench (included with base). Be sure the arm is
tight but rotates freely.
Repeat for other arm.
Once arms are attached, tighten installed set screws with 2.5
mm Allen Wrench (included with base) to fix Arms in place.
Install End Caps (B).
Attaching Conform Static Arms
Remove the set of two M8 × 66 mm Articulating Bolts and
Washers from the Dual Arm Adaptor.
Replace the pre-installed Articulating Arm Spacers with the
Static Arm Spacers (C).
Replace the M8 × 66 mm pre-installed Articulating Arm Bolt with
the M8 × 63 mm Static Arm Bolt (B).
Insert the M8 × 63 mm Bolt with washers through the bottom of
the arm assembly and into the Adaptor as shown. Tighten with
5 mm Allen Wrench (included with base). Be sure the arm is
tight but rotates freely.
Repeat for other arm.
Once arms are attached, tighten installed set screws with 2.5
mm Allen Wrench (included with base) to fix Arms in place.
Install End Caps (B).
Optional
C-Clamp Base
Shown
Optional
Wall Plate Base
Shown
1500258 Rev A
2
3
a
a
b
Remove
Remove
Replace
Replace
c
c
c
c
d
d
d
e
e
e
e
f
f
g
g
f
f
d
a
a
b
b
b
Pin
Remove
Static arm
spacer
B
C
