1 of 2
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Attach Dual Arm Adaptor to selected base option
Remove the Bolt and Washers from base (if not already removed)
and set aside.
Place Dual Arm Adaptor Assembly (A) on the pin mount from your
selected base option.
Tighten the two pre-installed set screws with the 2.5 mm Allen Wrench
(included with base) to secure the Adaptor to the base. The adaptor
should be locked in place and not rotate.
A
Dual Arm Adaptor Assembly
Qty: 1
D
Dual Arm Adaptor
End Cap
Qty: 2
Parts Included
Assembly & Installation Instructions:
Dual Arm Adaptor CONF-ADPT-DA-S
Required Parts Sold Separately
Tools Required
B
Static Arm Bolt
M8 x 63 mm
Qty: 2
C
Static Arm Spacer
Qty: 2
Note:
If you are installing Articulating
Arms, proceed to Step 2.
If you are installing Static Arms,
proceed to Step 3.
Phillips head screwdriver, 2.5 mm Allen Wrench, 5 mm
Allen Wrench.
Conform Monitor Arm.
Selected base option with mounting hardware.
Do not use on hollow core tables.
Do not rotate or suspend arm (s) beyond table surface.
The weight difference between the two monitors should not
exceed 15 lb.
1
a
b
c
a
c
b
Optional C-Clamp
Base shown
A
