INTENDED USE
INSTALLING THE AUXILIARY HANDLES
INSTALLING THE BACKING PAD/FOAM
PAD
SET UP BEFORE USE
10
The machine is intended for polishing and sanding of
painted or fiberglass surfaces. For reasons of
electrical safety the machine must not be damp or
operated in a humid environment. The machine may
only be used for dry sanding, buffing or polishing.
Option 2: Using with a side handle (side handle
not included).
This tool can be used with many standard angle
grinder side handles which can be installed on
either side.
1.
The accessory MUST be:
Rated to at least 4000 rpm.
No larger than 7” (180 mm) in diameter.
Fitted with a threaded opening of 5/8”
Undamaged
A backing pad.
2.
Press in and hold the Spindle Lock Button to
prevent the Spindle from turning.
3.
Thread the Backing Pad onto the spindle until
firmly secured in place.
Insert hex key
through here to
access bolt
Install side
handle here
or here
TO PREVENT SERIOUS INJURY:
Do not operate
this tool without an auxiliary handle properly
installed.
The D-handle (included) may be installed for either
right-hand or left-hand use.
Option 1: using with the D-handle. Attach the
D-handle to the sides of the front cover, using the
hex key and two hex head bolts.
Note:
Slide the hex key through the hole in the
handle to access the bolt on the long side of the
handle.
WARNING!
To reduce the risk of injury, turn the unit off and
disconnect it from the power source before
installing and removing accessories, before
adjusting or making repairs. An accidental start-up
can cause injury.
WARNING!
To reduce the risk of injury, turn the unit off
and disconnect it from the power source
before installing and removing accessories,
before adjusting or making repairs. An
accidental start-up can cause injury.
To install pad or disc on Velcro backing plate,
center the pad or discover plate and press
firmly.
To remove pad or disc from Velcro backing
plate grip pad or disc firmly and pull from
plate.