Speaker Complement
(2) 10" custom designed cast-frame SWR drivers
(1) LeSon TLX-1 Piezo Tweeter
Cabinet Construction and Features
5/8" 7-ply, Maple or Birch plywood construction, waterproof glue.
All joints Dado and Rabbet, glued and nailed.
Front Slot Port designed to eliminate unwanted noise
Heavy Duty Removable Casters
Heavy Duty Spring Handles
Midnight Blue Carpeting with Stack Lock Corners
Midnight Blue Stamped Steel Vibration-Free Grill
Dimensions
23"W x 23"H x 16.75"D
Weight
76 lbs.
WORKINGMAN'S 2X10C - GETTING STARTED
WORKINGMAN'S 2X10C - GETTING STARTED
Remove the AC cable from the accessory pack and connect it from the amplifier to a standard wall outlet.
Make sure that the "Gain" and "Master Volume" controls are set to the minimum position (fully counter-
clockwise). Locate the power switch on the right side of the front of the unit and turn the amplifier on. Upon
powering up, don't be surprised if you hear a small pop. This is absolutely normal and will not cause damage
to your speaker system.
(Eliminating this "power on transient" would require a component called a relay. SWR chose not to incorporate
this type of component due to the fact that relays degrade signal quality and often fail, causing the unit to
have no output and requiring a trip to a local service center. If you wish not to hear the pop upon power up,
locate the "Speakers On/Off" switch on the front panel and set it to the down position before you turn the unit
on. Be sure to remember to set the switch back to "On" afterwards, or you may find yourself wondering why
you don't hear anything.)
Plug your instrument into the desired input jack (refer to "Front Panel Features" for greater detail). Turn your
instrument's volume up to at least 75% of maximum and slowly adjust the gain control. Once you begin to
play your instrument and you see the red light (marked "preamp clip") over the gain control illuminate, back
off the gain a bit. Now turn up the "Master Volume" and you should hear the sound of your instrument
amplified through the Workingman's 2x10C. For more detailed information, please read the entire manual
carefully so that you can fully realize the potential of your new Workingman's 2x10C.
For those who wish to use an extension speaker cabinet with the Workingman's 2x10C, please skip ahead to
the section marked "Extension Speaker Output Section" on page 10.
WORKINGMAN’S 2X10C OWNER’S MANUAL • 3
