7
Align the belt closure so the teeth mesh with each other and install the fastening pin into the teeth. Insert the fastening pin while
holding the closure together. When the fastening pin is fully inserted into the teeth, align or trim the pin as needed to avoid po-
tential damage to garments landing on the belt. Refer to page 8 for belt tracking procedures.
Thread the belt over the lower cross brace and through the lower slot on the roller/rail assembly. Guide the belt through the oven
chamber, through the lower slot and over the lower cross brace on the opposite roller/rail assembly. Pull the belt around the out-
side of the roller and over the top of the upper cross brace. Thread the belt through the oven chamber and over the upper cross
brace until both ends of the belt meet.
Belt Installation
Summary of Contents for Mercury compact dryer
Page 1: ...PN 67 1465 REV A 3 13...