4
•
Beginners should use this device only under supervision of any other adult, who helps them to
keep balance.
•
Try correct riding before first using to avoid damage or injury.
SAFE USING AND MAINTENANCE
1. Before each riding check that all screws, bearings, wheels and components are well tightened
and that they are not damaged. Moreover, check the handlebars adjustment (steering
system). You can start your driving only if all components fit well.
2.
Before each using check the scooter surface for cracks and dents. If you find them, don’t use
this device and replace worn components immediately.
Don’t use this device, if you find some
sharp edges on the frame.
3. Check your scooter regularly for wearing or damage. Only so it can comply with safety
precautions. Proper maintenance can increase its safety. Never use damaged device.
4. Check scooter handling before each riding. When the wheels draw sideward you should check
if they are well tightened. If they d
on’t rotate smoothly you, lubricate the bearings with mild
engine oil. If they still don’t go smoothly or if they are damaged replace them immediately. By
unequal wheel wearing from one side turn them by 180
°.
5. Self-locking nuts and self-locking parts are generally susceptible to often tightening and
releasing. Doing it you can decrease their effectiveness. Worn components must be replaced
immediately.
6.
Don’t make any improper adjustment or improper maintenance. Follow instructions of this
manual.
7.
Use only soapy water and soft cloth to clean this device. Don’t use solvents, dyes, glues or
other aggressive agents. Don’t use rough materials. They could totally damage the scooter.
Don’t use any abrasive. It could scratch the scooter surface.
8. Store it in a dry, dark and cold place. This place must be well ventilated, protected from direct
sun shining and dust.
ASSEMBLY STEPS
1. Release the bolt on the folding mechanism and hoist the scooter slightly. Pull the middle lever
upwards. The handlebars tube gets loose.
2. Pull the tube upwards until it will be at the right angle against the footboard. Then pull the lever
downwards. The screw will snap in the second hole. Tighten well the quick-release bolt.
3. Loosen the quick release lever on the handlebar tube and adjust right height. Snap pin into
hole outwards. Close the quick release lever.
4.
Adjust the handlebars in “T” shape. The spring buttons, which stick out, must snap in properly.
5. Follow these steps in reverse order to dismantle this scooter.
