5
(c) Fork tube
(d) Tighten the stem bolt
Hand Brakes Assembly and Adjustment
WARNING:
The hand brakes on this scooter were not adjusted at the factory. Before you ride the
scooter you must assemble and adjust the hand brakes. Install brake levers onto the handlebar. The
brake lever on the left hand side connects to the front brake, and the brake lever on the right hand
side connects the rear brake.
1. Squeeze the rear brake arms with your hand until the brake pads are up against the wheel
rim. This will enable the inner brake cable wire to tighten and
you’ll have enough space to
easily slip the barrel end of the brake cable wire into the hole in the brake lever.
2. Insert the brake cable wire into the slot in the front of the brake lever and then remove your
hand. The brake cable cap will automatically spring back into the slot on the front of the brake
lever assemble.
Hand brakes adjustment:
a) Loosen the anchor bolt nut.
b) Squeeze the brake pads against the wheel rim again.
c) Pull the brake cable wire through the anchor bolt hole until there is no slack in the inner
brake wire.
d) Tighten the anchor bolt nut.
e) Squeeze the brake lever hard and then release it several times. Rotate the wheel; make
sure it does not wobble. There should be about 1.6 mm clearance between the wheel rim
and each brake pad.
