5
Use the following procedure when first turning on your system:
1.
Turn down the level of your audio source.
2.
Turn down the level controls of the amplifier.
3.
Power up the mixer. The display is lighting.
4.
Power up the amplifier that is connected to the mixer output.
5.
Turn up the level of your audio source to an op mum level.
6.
Turn up the level of your mixer to an op mum level.
7.
Turn up the Level controls on the amplifier un l the desired loudness or power level is achieved.
If you ever need to make any wiring or installation changes, don't forget to disconnect the power cord.
Note:
To avoid pop noises when powering down your system, it is recommended that the amplifier used to drive the
loudspeakers be turned off before the other system components.
This functionality allows to set a value (TARGET) marked as maximum level of the channel, and another parameter
(GAIN), which marks the quantity of amplification that the channel needs to reach the TARGET value. This functionality
provides several configurations according to the installation requirements. One op on will be to set the same TARGET
threshold in all channels in order the all microphones have the same level. Another op on will be to set several TARGET
values on each channel in order that these channels will have preponderance over the rest.
This gain correction is made in real me, allowing an autonomous control in the installation without being worried about
the controls once set the desired configuration.
2.5
Startup Procedure
3.0
Automixer (Explanation)
