※
Document Revision V 1.0 20200721 Copyright © 2017 Wooshin Press Lighting Inc. All rights reserved. / www.wsled.co.kr
WSG-P
Series
Installation Guide
LED Sports Flood Lighting
Model : WSG-P960 (Remote Driver type)
Cable Connection Guide
Installation Instruction
[ How to Connect the Power cable and AC/DC cable ]
①
After connecting with a sleeve, wrap it with a
self-sealing tape.
②
In order to prevent flooding with the gap between
outer part of the cap tire cable and the connecting
part, wrap up the connecting part of the power
supply line and the AC/DC line with a self-sealing tape.
③
After wrapping it up with the self-sealing tape, use
electrical tape on top of it.
Do not leave the power box and LED fixture unconnected
(Multiple installation schedule and wiring is prohibited).
In case of inevitable connection of the secondary side
during construction, insulate the ends of the wires with
insulation tape and self-sealing tape to waterproof it.
If following steps are not followed, it may cause product
damage, poor insulation, immersion, non-lighting, short life,
or fire.
Precautions during construction
Self-sealing Tape
①
②
③
Self-sealing Tape
Electrical Tape
※
Caution / Warning
-
The power line is reliably connected with a sleeve or the like. In addition, the insulation tape and self-sealing tape are
used to reliably insulated and completely waterproof. If the power cable is incompletely connected, there is a risk of
product damage, electric shock or fire.
-
When connecting wires, do not insulate them once, but separate them one by one. Insulate and waterproof them with
insulating tape and self-sealing tape. Insufficient construction may cause product damage, poor insulation, flooding,
electric shock or fire.
-
When wiring, use insulation tape and self-sealing tape from the connection part of the wire to the outer sheath of the
wire. Apply over three times (6 plies) of insulation and complete waterproo ng. Insu cient construction may cause
product damage, poor insulation, flooding, electric shock or fire.
-
Insulate each end with self-sealing tape and then tap from the AC / DC side (sheath) to the outer side of the power line.
Then, wrap it with insulating tape and implement insulation and waterproofing measures.
-
Make sure to insulate and waterproof the cable sheath (self-sealing tape, etc.), including the cable sheath as well as the
conductor. If the insulation/waterproofing is not done properly, immersion may occur from the electric wires, resulting in
product damage, poor insulation, electric shock, fire, or non-lighting.
