Woodward HighPROtec MCDLV4, Manual

Page: 325 / 1275

Communication Protocols
Parameter Description Setting range Default Menu path
Activate Block
MD
This Direct Control parameter activates (or
deactivates) the blocking of IEC103
transmission in monitor direction.
inactive,
active
inactive [Service
/Test (Prot
inhibit)
/Scada
/IEC 103]
Res all Diag Cr Reset all diagnosis counters inactive,
active
inactive [Operation
/Reset]
IEC60870-5-103 Input States
Name Description Assignment via
Ex activate test
mode-I Module input state: Test Mode of the IEC103
communication. [Service
/Test (Prot inhibit)
/Scada
/IEC 103]
Ex activate Block
MD-I
Module input state: Activation of the blocking of
IEC103 transmission in monitor direction.
[Service
/Test (Prot inhibit)
/Scada
/IEC 103]
IEC60870-5-103 Signals (Output States)
Signal Description
Scada Cmd 1 Scada Command
Scada Cmd 2 Scada Command
Scada Cmd 3 Scada Command
Scada Cmd 4 Scada Command
Scada Cmd 5 Scada Command
Scada Cmd 6 Scada Command
Scada Cmd 7 Scada Command
Scada Cmd 8 Scada Command
Scada Cmd 9 Scada Command
Scada Cmd 10 Scada Command
Transmission Signal: SCADA active
Failure Event lost Failure event lost
Test mode active Signal: IEC103 communication has been switched over into Test Mode.
Block MD active Signal: The blocking of IEC103 transmission in monitor direction has been
activated.
325 MCDLV4 DOK-HB-MCDLV4-2E