Woodward easYgen-3000XT Series, Manual, Page: 671 / 1205

5 Operation
In operation the genset controller can be manually or remote controlled.
Front panel access is described in chapter ╚═▷ “4.1 Front Panel Access” .
Access via ToolKit is described in the ToolKit Manual.
Access via Remote Panel PR-3000XT is described in chapter ╚═▷ “4.3.6 Configure Remote
Panel Mode” and the Technical Manual »37593 RP-3000XT«.
Access via PLC depends on the interface and the data telegram used for communication.
For menu structure/menu tree see ╚═▷ “Menu structure (menu tree)” .
5.1 Power ON
Behavior during starting easYgen-3000XT
The start-up procedure of the easYgen-XT device can be caused by the following reasons:
• Power ON •
• Power cycling e.g. by ╚═▷ 1701 » Set factory default values« •
• Power is back after voltage drop •
This process is visualized by the HMI of the plastic housing version or the LEDs of the
metal housing version.
Using the USB Service Port
With power ON and a PC/laptop connected via USB service port it can happen that the
USB window that pops up doesn't show all files and/or the correct available free memory
at the device: Please unplug/plug the USB connection after the easYgen finished starting.
With power ON and connected USB service port it can happen that a connected USB
device is not detected correctly: Please unplug/plug the USB connection after the
easYgen finished starting.
With power cycle or reboot of the easYgen-XT the USB connection is lost: Please unplug/
plug and/or start USB connection again after the easYgen finished starting.
... starting plastic housing (HMI) version
Power ON from zero power
• Buttons are illuminated •
• Start-up screen appears •
◦ the red bar at the bottom monitors the degree of fulfillment ◦
• HOME screen appears with measured values and state information •
671 easYgen-3000XT Series B37574
5 Operation
Released