Manual 37429
easYgen-2000 Series - Genset Control
© Woodward
Page 19/41
Configure the
LogicsManager
function "Setp. 2 load" as shown in Figure 4-2 on page 19 to enable load setpoint 2
if discrete input [DI 04] is energized.
Figure 4-2: Example - configuring load setpoint 2 for [DI 04]
Viewing the Load Set Point on the easYgen
After the unit is configured as described above, the "Setpoint" screen may be viewed from the main screen by se-
lecting Main menu -> Setpoints.
Figure 4-3 shows the "Setpoint" screen with enabled load setpoint 2 ([DI 04] is energized). This is indicated by
the figure "2" in front of the load setpoint section.
Figure 4-3: Example - Setpoints screen
The "Analog inputs" screen may be viewed from the main screen by selecting Main menu -> Measured values ->
Analog inputs/outputs.
Figure 4-3 shows the "Analog inputs" screen. Scroll down the display to analog input [AI 03] at the bottom.
Figure 4-4: Example - Analog inputs screen