-19-
Model W1866 (For Machines Mfd. Since 11/18)
SE
TU
P
Assembly
Figure.11.
Stand legs aligned and correctly
positioned 48
1
⁄
4
" apart.
Figure.12.
Chisel pan components
installed on stand.
Figure.13.
Chisel pan hex nut and flat
washer installed.
Before beginning the assembly process, refer to
Items.
Needed.for.Setup
and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the
Test.Run.
or connecting
the machine to power.
To.assemble.machine,.do.these.steps:
1. Position stand legs upright approximately 48
1
⁄
4
"
apart, and align them reasonably well (see
Figure
11
).
Assembling the W1866 lathe consists of attaching the legs
to the lathe bed, and then attaching the chuck guard,
tool rack, and chisel pan.
48
1
⁄
4
"
2. Insert chisel pan mounting rod into two brackets
underneath chisel pan (see
Figure
12
).
Note:
Install the chisel pan as shown in
Figure 12
so the open end will face the front of the lathe
bedway when it is installed in
Step 8
.
3. Install (1) M12-1.75 hex nut and (1) 12mm flat
washer on each end of mounting rod, then insert
into designated hole on each leg (see
Figures
12
–
13
)
and loosely secure with (2) M12-1.75 lock nuts and
12mm flat washers.
Note:.
The lock nuts on the chisel pan mounting rod
should not be tightened until the lathe bedway has
been installed.
Mounting
Bracket
(1 of 2)
Chisel Pan
Mounting
Rod
Hex Nut &
Flat Washer
x 2
Summary of Contents for W1866
Page 57: ...Model W1866 For Machines Mfd Since 11 18...
Page 60: ......
