Woodstock STEELEX ST1000, Owner'S Manual, Page: 21 / 52

ST1000 14" Bandsaw
-19-
Figure 25. Dollar bill folded twice to make a quick
0.016" gauge.
9. Tighten the support bearing lock bolt to keep
the support bearing locked in place.
NOTICE
Whenever changing a blade or adjusting ten-
sion and tracking, the upper and lower blade
support bearings and guide-blocks must be
properly adjusted before cutting operations.
The blade guides provide side-to-side support to
help keep the blade straight while cutting. The
blade guides are designed to be adjusted in two
ways—forward/backward and side-to-side. Properly
adjusted blade guides are essential to making accu-
rate cuts.
To adjust the upper and lower blade guides:
1.
Make sure that the blade is tracking properly
and that it is correctly tensioned.
2. UNPLUG THE BANDSAW!
3. Familiarize yourself with the blade guide con-
trols shown in
Figure 26
.
Adjusting Blade
Guides
Figure 26. Blade guide controls.
4. Loosen the thumbscrew on the adjustment
rod.
Blade
Guide
Blocks
Thumbscrews
Adjustment
Rod
Note: For a quick gauge, fold a dollar bill in half
twice (four thicknesses of a dollar bill is approxi-
mately 0.016") and place it between the support
bearing and the blade as shown in
Figure 25
.