Woodstock Shopfox W1766, Owner'S Manual, Page: 21 / 32

-19-
W1766
1
⁄
2
HP Power Feeder
M
A
INTE
N
A
N
CE
MAINTENANCE
Lubrication
•
To prevent surface rust and binding, periodically
clean and oil all lock lever and lead screw threads
with a light machine oil.
•
After the first month or 200 hours of use, change the
gearbox oil with 4.5 fluid ounces of an automotive
grade 80-90W gear oil. For the remaining life of the
power feeder, change the oil every 6 months or 1000
hours of use.
Note:
To drain the unit, remove the
fill plug labeled " OIL " ( Figure 14 ) and invert the
power feeder.
•
Every 40 hours of use, or once every two weeks,
wipe clean and lubricate the wheel grease fittings
(
Figure 13
) with one pump of a grease gun filled
with automotive grade GL-2 grease.
• To prevent rust and binding, paint the sprockets,
chain, and change gears (
Figure 14
) with a light film
of an automotive grade GL-2 grade grease.
•
Frequently blow-off sawdust with compressed air.
This is especially important for the internal working
parts and motor. Dust build-up around the motor is a
sure way to decrease its life span.
• If the wheels become loaded up with pitch, oil, or
other residues, wipe them clean using a clean rag
and a mild solvent. Avoid touching the plastic or
paint with mineral spirits or you may damage the
surfaces.
Cleaning
Regular periodic maintenance on your machine will
ensure its optimum performance. Make a habit of
inspecting your machine each time you use it.
Check for the following conditions and repair or
replace when necessary:
•
Loose mounting bolts and damaged wheel rubber.
•
Worn or damaged, switch, cord, and plug.
•
Any other condition that could hamper the safe
operation of this power feeder.
General
MAKE SURE that your machine is
unplugged during all maintenance
procedures! If this warning is ignored,
serious personal injury may occur.
Figure 13. Wheel lubrication.
Figure 14.
Sprockets, chain,
and change gears
Grease
Fitting
Change
Gear
Sprocket Chain
Oil Fill
Plug