Woodstock Shop Fox W1679, Instruction Manual, Page: 14 / 44

Figure 11. Motor mount bolts inside
dust chute (two are not shown).
Installing V-Belt
ASSEMBLY
-12-
Beginning
Although the main components of the Shop Fox ®
W1679 are assembled at the factory, some
assembly is required. The following series of
instructions are the recommended sequence
best suited for final assembly.
Mounting Jointer
1.
Determine the best place for the jointer in
your shop and place the cabinet stand in
that location.
2.
With the help of a friend, lift the jointer
assembly onto the stand so the cutterhead
pulley is positioned directly over the slot in
the top of the stand.
3.
Align the mounting holes (
shown in Figure
10
) on the stand to the jointer assembly,
and secure the jointer assembly with the (3)
3
⁄
8
" - 16 x
3
⁄
4
" hex bolts and lock washers
from the hardware bag.
Figure 10.
Secure table to stand at these locations.
Make sure that your
machine is unplugged
during all assembly pro-
cedures! If this warning
is ignored, serious per-
sonal injury may occur.
1. Figure 11
shows the jointer motor mount
bolts inside of the dust chute. Loosen the
nuts so you can slide the motor up and
install the V-belt.
2.
With the V-belt in the grooves of both the
motor pulley and the cutterhead pulley,
pull the motor down tightly by hand and
tighten one corner bolt.
3.
Place your straightedge against the face of
both pulleys, and swivel the motor as nec-
essary until both pulleys line up with each
other. Tighten the other three motor mount
bolts.