Woodstock SHOP FOX M1011, Instruction Manual

Page: 5 / 16

-3-
INTRODUCTION
M1011 24" Pan and Box Brake
Controls and Features
A. Holddown Assembly —Applies clamping pres-
sure to the sheet metal to be bent.
B. Holddown Finger Channel —Allows for the
finger T-nut to slide down the length of the
holddown to adjust for different widths of
sheet metal.
C. Holddown Clamping Lever —Allows you to
clamp and unclamp the sheet metal through
the cam mechanism.
D. Holddown Stop Flange —Allows for quick
indexing of one or many fingers.
E. Holddown Height Turnbuckle —Allows for
adjusting the holddown clamping height so
metal of various thicknesses can be clamped
and bent.
F. Finger Position Control —Allows for adjusting
the holddown and fingers to move them clos-
er or farther away from the point of bend.
G. Apron —Allows for even bending and support
for sheet metal.
H. Apron Face —Applies even pressure along the
surface of the sheet metal during the bend.
I. Apron Lever —Allows you to bend the sheet
metal with two levers.
J. Finger Knife-Edge —Allows for extremely
sharp bend if required.
K. High-Strength Fingers —Allows for bending
many different widths of metal.
L. Body —Supports all components and is drilled
for mounting on a heavy duty workbench.
Figure 1. Typical M1011 24" Pan and box brake controls and features.
C
E
F F
G
I
K
J
L
A
E
B
H
Use the list below and Figure 1 to become familiar with your new pan and box brake.
D