Woodstock M1107, Owner'S Manual

Page: 12 / 24

-10-
M1107 Bench grinder
SET
UP
Test Run
Once your machine is mounted and assembled, you should
perform a test run to make sure it works properly.
To perform a test run, do these steps:
1.
Make sure all tools are removed from the grinder
area.
2. Make sure the switch is in the OFF position.
3. Plug the grinder into the power source.
4. Turn the grinder ON . Under normal conditions, the
grinder will make a humming noise, with only minor
vibration.
— If you suspect any problems, immediately turn
the grinder OFF and refer to
Page 15
to trouble-
shoot and correct any problems before starting the
grinder again.
— If the source of an unusual noise or vibration is not
readily apparent, contact our technical support
for help at (360) 734-3482 or contact us online at
tech-support@shopfox.biz.
DO NOT investigate problems or adjust
the bench grinder while it is running.
Wait until the machine is turned
OFF
,
unplugged and the spindle has come
to a complete stop before proceed-
ing!