Page 10
Operation
Operating Instructions
First Time Operation (W.GPC61SC, W.GPC62SC)
Note:
By pressing the programme button again, it will automatically go to the next timer display in order of sequence, i�e� 1,2,3,4
- 1, 2, 3, 4
)�
The temperature can only be adjusted after the toaster has been turned on and allowed to operate through 2-3 cycles�
Upon setting up your equipment, the following steps must be followed to setup the timer and temperature:
When this unit is initially switched on, the display will show pre-set factory settings�
The Control panel has 8 timers located along the front of the control panel� The displays indicate the pre-programmed times in minutes and
seconds�
1� To change the
“TIME”
settings, Press and hold the
“Prog”
Programme Button for 3-4 seconds
2� Display 1 will flash
3� Press the
˅ ˄
buttons to adjust time if necessary
4� Press the
“Set”
Set button
5� Repeat the above steps for the other display timer buttons if necessary (i�e� 1, 2, 3, 4 - 1, 2, 3, 4)
1� Ensure that the top plate is in a closed position
2� Turn the power switch to the desired mode i�e� Top and bottom plate for normal press toasting, Bottom plate for Griddle style operation
or Standby� The power
“ON”
indication light located on the L/H side control panel and Power ready light will be illuminated� If the
indicator light does not illuminate refer to the trouble shooting section of the manual
3� Allow the press toaster to preheat for approximately 30 minutes� The
“Temp Ready”
indicator light will turn itself “OFF” once the
press toaster has reached its optimum operating temperature� The press toaster is preset to operate between 205°C - 210°C surface
cooking temperature
4� Ensure that the 4 display timers are set to the desired cook time on the control panel (refer to programming the toaster instructions in
this manual)
5� Lift the top plate up to a fully open position by the handle provided
6� The top plate will remain in the open position, as it is spring-loaded
7� Take extreme care when lifting, do not touch the cover or cooking surface to avoid skin burns
8� Place the food product onto the cooking surface and close the top plate
9� Ensure that the product is placed centrally of the cooking surface, to prevent the top plate from tilting and producing uneven product�
10� Press the appropriate display timer button (i�e� 1,2,3,4) to start the cooking procedure� The time shown in the window above the
corresponding button will begin to count down
11� Once the count down timer reaches “000”, the timer will emit a beeping sound� Press the appropriate display timer button again, to
de-activate the timer� Lift the top plate fully to the open position and remove the toasted product
12� Close the top plate
Operation (W.GPC61SC, W.GPC62SC)
Note:
Do not use the press toaster until the temperature ready light is off, as you will not achieve optimum product quality results�
Note:
The timer can be stopped if necessary, by pressing the timer button and holding it for 3 seconds�
Note:
To ensure optimum product quality, the top plate must be closed after every operation of unit, to maintain constant temperature�