Page 6
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Installation
Aggregate electrical ratings of the Unit are expressed in kilowatts in this manual�
Single Phase Units:
Supplied with an appropriately rated plug and lead fi tted and be indicated as:
• 10A plug & lead fi tted
• 15A plug & lead fi tted
• 20A plug & lead fi tted
OR
A terminal block for on-site connection, by a licensed electrician will be supplied inside the service compartment of the unit and be indicated
as:
• 1Ø + N + E
Three Phase Units:
A terminal block for on-site connection, by a licensed electrician will be supplied inside the service compartment of the unit and be indicated
as:
• 3Ø + N + E
Plug and lead Connection:
• Plug the unit into the applicable power point�
Some procedures in this manual require the power to the equipment to be turned
off and isolated. Turn the power OFF at the power point and unplug the power
supply lead by the plug body. If the power point is not readily accessible turn the
equipment off at the isolation switch or the circuit breaker in the switchboard.
Attach a yellow “CAUTION-DO NOT OPERATE” tag. This must be performed
where relevant unless the procedures specify otherwise.
FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.
WARNING
WARNING
This unit must be installed in accordance with AS/NZS 60335.1
On-site Connection:
• The electrical supply must comply with the rating plate data
• Ensure that the machine is connected to a suitably rated power source
• Disconnection must be incorporated in the fi xed wiring in accordance with the wiring rules
• To connect the power, the unit has a terminal block supplied inside the service compartment
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a
hazard� Please contact Stoddart for parts and we will advise how to do this in order to avoid any electrical hazard
Electrical Connection
Information
Note:
This unit can be 1Ø or 3Ø by removing the bridge� See electrical diagram Page 11