EASILIFT 24/08/21
FITTING THE CANOPY: After assembling the base and making sure the fastening handwheel is loosened, remove the umbrella structure from the protective bag, remove
all protective wrapping and place the umbrella pole into the base tube, tightening the handwheel to ensure the umbrella is secured. To fit the canopy you will require a
step ladder (although this process can also be done while laying the umbrella structure on its side on a clean flat surface, taking special care not to dirty the canopy).
2) Remove the canopy from the protective bag
and locate the eyelet at the canopy top that the
tubular finial base fits through.
3) Insert one hand into the underside of the
canopy under the finial eyelet. With your free
hand then insert the tubular base of the finial
through the finial eyelet on the canopy top.
4) Turn the canopy upside down so the tubular
threaded base of the finial sticks out slightly.
5) Then place the threaded finial base onto the
bolt head that you just removed the nut from in
step 1 at the top of the umbrella’s top dome.
6) Once the finial is on top of the threaded bolt
carefully drape the canopy down over the
umbrella structure.
7) Hand tighten the finial into position, turning
clockwise while ensuring the finial is vertically
orientated so as not to damage the threads.
8) To attach the canopy to the ribs, use your
fingers to pull the top half of the LOXX fastener
up, and place onto the ball stud mounted on the
rib end. Release the top half of the LOXX
fastener. Repeat until all corners are attached.
FINIAL
EYELET
FINIAL
THREADED
TUBULAR BASE
OF FINIAL
THREADED
TUBULAR BASE
OF FINIAL
PROTRUDING
BOLT HEAD
PROTRUDING
BOLT HEAD
STRAPS
TOP DOME OF
STRUCTURE
CANOPY
UNDERSIDE
1- LIFT UP THE TOP OF
THE LOXX FASTENER
2 - PLACE
UNDERSIDE OF
FASTENER OVER
BALL STUD ON
THE RIB END
3 - RELEASE
LOXX FASTENER
TO CONNECT CANOPY
TO THE RIB ENDS
3/6
1) Using a step ladder get up to the same height
as the top of the umbrella then unscrew and
discard the nut protruding from the top dome.
PROTRUDING
BOLT HEAD
WITH NUT
PROTRUDING
BOLT HEAD
WITH NUT
THIS NUT CAN BE
REMOVED AND
DISCARDED PRIOR
TO INSTALLING
THE FINIAL
THIS NUT MUST BE
REMOVED AND
DISCARDED PRIOR
TO INSTALLING
THE FINIAL
STRAPS
TOP DOME OF
STRUCTURE
