Wooden peg 8 x 36 mm
Screw 35 mm
Diagram 1.4
Diagram 1.4
Spax-Schraube 35 mm
Diagram 1.5
Diagram 1.5
W9
W9
W2
W2
Spaxschraube 35mm
Schubladenboden in Nut einfügen
Diagram 1.2
Diagram 1.2
Seite 2
Before installing slats for mattress support assemble the
drawers
together. Place drawer board in the notch
between the font and back board and attach the side
boards to front and back boards with screws ( ) .
Fix small wheels on a wooden block attached to the side
boards
( ). Both drawers should be placed from the top
through the space between the beams W1 and W2 from
inside to outside . Corner boards
F1, F2 and F3
should be
attached to the beams Z30/Z31, S1/Z32 and S7/S8 with
40
x 40-mm-Brackets
. So that the drawers slide along the
corner boards. The corner boards with wider ends should
be positioned in the back ( ).
Diagram1.2
Diagram1.2
Diagram 1.3
Diagram 1.3
Diagram 1.3
Diagram 1.3
Diagram 1.3
Diagram 1.3
F2
F3
Fix wheels to the wooden
blocks from below using
the screw 16 mm.
Z31
Z32
W1
Install the drawer on the right side between the corner
board F1 and beams S2 and S7.
W8
Assemble
corner beams Z30 and Z31as well as middle beam Z32
. Be aware that the surface of the beams
Z30, Z31 with round
indentations face the direction of the middle beam.
Continue the assembly using the diagrams + .
For
mattress support beams W2 and W9
has a notch to support the mattress slats, which is positioned to face upward. The
beams on the end of the bed (
W13, W14, W19 and W20)
are fixed together at the corner with additional flathead bolt (vertically
attached) and fixed with washer and nut.
1.
1.
2.
2.
The slatted frame:
as shown in 15 wooden peg
should be placed between each slats. The peg is attached to
one side of every slat except for the 16th slat. Slats are placed
on the notch of beams W2 and W9, W3 and W10 and fixed
with wooden screws.
The slatted frame should only be
used with a mattress on top for safety since there are
space between the slats.
Other option: If you would like a bunk bed without a
mattress, an extra slat can be added (“Spielboden-Set”,
Best. Nr. 650). The wooden pegs should be taken out and
collected for later use. ( ).
Diagram 1.4
Diagram 1.4
Diagram1.5
Diagram1.5
After approximately three weeks tighten falthead bolts
again. But be careful not to tighten too much that the head
of the bolt buries inside the wood.
If you have any technical questions to build the bed please
contact us on
0049 2133 2482 - 19
. The WOODLAND team
hope that you and your family will enjoy the WOODLAND
adventure beds!
Keep the cover for round
indentations away from small
children!
CAUTION!
First attach the bracket on the board
F2 so that the drawers slide in
smoothly.
WOODLAND reserves the right for printing errors © Copyrights by WOODLAND 1998
R
